Artificial trees harvest energy from the wind

Artificial trees harvest energy from the wind

Researchers at Ohio State University (Columbus, Ohio) have shown that tree-like structures made with electromechanical materials are suitable for converting winds or structural vibrations into electricity.
By eeNews Europe

Share:

The "trees" would be relatively simple structures – a trunk with a few branches and no leaves – and they may not be scaled up to sit among conventional forests or compete with windmills or solar farms. More likely they would be used at the small scale to power sensors that monitor the structural integrity of buildings, bridges, and other civil engineering structures.

"Buildings sway ever so slightly in the wind, bridges oscillate when we drive on them and car suspensions absorb bumps in the road," said project leader Ryan Harne, assistant professor of mechanical and aerospace engineering at Ohio State, and director of the Laboratory of Sound and Vibration Research, in a statement. "In fact, there’s a massive amount of kinetic energy associated with those motions that is otherwise lost. We want to recover and recycle some of that energy."

Harne envisions tiny "trees" feeding voltages to a sensor on the underside of a bridge, or on a girder deep inside a high-rise building. In this way structural monitoring systems could be powered by the vibrations they are monitoring.

Previously it was assumed that mechanical structures would not be good at collecting energy from a wide spectrum of vibration. Harne showed by mathematical modeling that this was not the case and that it should be possible to exploit internal resonance to get an electromechanical tree to vibrate at large amplitudes at a consistent low frequency even when the tree was experiencing random inputs or only high-frequency forces.

To test the math Harne and colleagues built a tree-like structure out of small steel beams connected by an electromechanical material polyvinylidene fluoride (PVDF) that would convert the movement into electrical energy. From a noisy high-frequency input it was possible to put the structure into low frequency oscillation producing an energy source at 2V.

"In addition, we introduced massive amounts of noise, and found that the saturation phenomenon is very robust, and the voltage output reliable. That wasn’t known before," Harne said.

The work was reported in the Journal of Sound and Vibration: "Leveraging nonlinear saturation-based phenomena in an L-shaped vibration energy harvesting system."

Related articles:
New energy harvesting method harnesses power from walking, other small motions
Smart roads to harvest clean power from traffic
Energy harvesting market set for 20% CAGR
Energy harvesters power wearables
Shock absorber harvests energy from car’s suspension

Smart2.0
10s